Camelback Drill Press Information Submission

If you would like to add your drill to the Camelback Drill Visual Database please provide the following information.

1. Manufacturer of the drill

2. The drilling capacity of the drill. This is measured from the center of the spindle to the column, then you double this measurement and that is the capacity of the drill. Basically the diameter of a pizza you could spin if you fixed the center of the pizza to the center of the spindle :).

3. Any additional information that you may have about the drill such as the date of manufacture.

4. Pictures of your drill. Please send high resolution pictures so that lots of detail can be seen in your pictures.

Since this site is still in its Beta form I am going to ask that you contact me through the practical machinist site. You can reach me on the practical machinist website by searching for the user name rudolf. I have enabled email through the the practical machinist site so you can send me an email and we can get the submission underway.

modified 3/9/08 jf